Aquabiome Bead Filter ASM750 - 30in

Filtration Systems - Bead & Sand Filters - Sieves - Vortex etc › Bead Filters › Waterco - Aquabiome Bead Filter › Aquabiome Bead Filter ASM750 - 30in

\nAquabiome is designed for ponds and water gardens. It provides mechanical and biological filtration in a single housing. Its ability to support dense populations of nitrifying bacteria and its reliability and easy maintenance, makes Aquabiome especially suitable for high density recirculation systems. The Benefits Of Using An Aquabiome Bead Filter The principal of using an Aquabiome Bead Filter is to combine the Biological filtration aspect with the mechanical filtration.  By combining these two filtration aspects the system can be more compact than a traditional - conventional pond filter system.  In addition, the Aquabiome requires far less pressure than a conventional Hi Rate sand filter, therefore the type of pump needed will require far less power.  Possibly reducing power use by 50%! Perhaps most important of all, an Aquabiome will require far less maintenance – cleaning or back washing than a typical Hi Rate pressure sand filter. The Aquabiome should be installed after your strainer/Vortex and main biological filter system.  Once installed, the Aquabiome will remove suspended solids down to 10 microns in size, maintaining your water clarity to a very high standard. The pumped water is fed to the Multi-port valve and diverted to the lower filter inlet. The inflowing water is evenly dispersed through the special slotted pipes (Laterals) within the lower section of the filter. The contaminated water flows upwards through the filter vessel depositing waste matter between the crevices of the Biomedia. To assist the growth of Bacteria for removal of the Ammonia present in the contaminated inflowing water, you will need to charge the system with: ‘Filter Start’. Once added to the inflowing water, good bacteria will begin to colonise on the filter media enhancing the biological action. The Aquabiome is designed to reduce the amount of maintenance (and waste water) required and ideally if the equipment has been correctly sized, backwashing will only be required on a weekly basis. The backwashing process is assisted by the use of a very powerful blower (air compressor) and the whole procedure will take less than 5 minutes to perform. Aquabiome ASM750 ~ Max Pond Size:  13000 gls / 59000 ~ Max Flow Rate:  6000 gph / 25500 lph ~ Inlet/Outlet Connections:  50mm / 63mm ~ Valve Size:  50mm / 2" ~ Tank Diameter:  772mm / 30.4" ~ Guarantee:  12 mth warranty on materials and workmanship CLICK HERE For Product Brochure CLICK HERE For Product Manual Product Variants FT-9486 £ 1577.87